euroquartz limited blacknell lane crewkerne somerset uk ta18 7he tel: +44 (0)1460 230000 fax: +44 (0)1460 230001 info@euroquartz.co.uk www.euroquartz.co.uk euro quartz description hpf576 series lvpecl output oscillators cover the frequency range 38mhz to 640mhz. the part contains a high 'q' fundamental crystal and utilizes a low jitter multiplier circuit. integrated phase jitter 0.4ps typical. outline & dimensions frequency range: 38.0mhz to 640.0mhz output logic lvpecl phase noise: see table frequency stability: see table operating temp range commercial: -10 to +70c industrial: -40 to +85c input voltage: +2.5v or +3.3vdc 5% output voltage high '1': vdd -1.025v min. low '0': vdd -1.620v max. (rl = 50 w to vdd -2.0v) rise/fall times: 0.7ns typical (20% vdd to 80% vdd) current consumption (15pf load): 38mhz to 100mhz: 65ma max. 100.01 to 320mhz: 80ma max. 320.01 to 640mhz: 90ma max. load: 50 w into vdd-2.0v start-up time: 5ms typ., 10ms max. duty cycle: 50%5% (at vdd -1.3v) input static discharge prot: 2kv min. storage temperature range: -55c to +150c ageing: 3ppm per year max., 2ppm thereafter. at t amb +25c enable/disable no connection: both outputs enabled disable: both outputs are disabled when control pad is taken below 0.3v referenced to ground. oscillator is always 'on'. (special request - oscillator is off when disabled.) enable: both outputs are enabled when control pad is taken above 0.7 vcc referenced to ground. absolute maximum ratings ( permanent damage may be caused if operated beyond these limits. ) supply voltage vdd: +4.6v max. input voltage vi: vss -0.5 min., vdd +0.5v max. input voltage vo: vss -0.5 min., vdd +0.5v max. specification part numbers hpf576 oscillator part numbers are derived as follows: example: 3hpf5762-a-250.000 hpf576 pecl oscillators 7 x 5 x 1.8mm 6 pad smd supply voltage 25 = 2.5vdc 3 = 3.3vdc series designation package style 5761 or 5762 stability code (see table) frequency stability over temperature range stability temperature range order code ppm c 25 -10 to +70 a 50 -10 to +70 b 100 -10 to +70 c 25 -40 to +85 d 50 -40 to +85 e 100 -40 to +85 f offset 10hz -62 100hz -92 1khz -120 10khz -132 100khz -128 1mhz -140 10mhz -150 dbc/hz phase noise (156.250mhz) jitter (at fr = 156.520mhz) integrated phase jitter: 0.4ps typical, 0.5ps max. (12khz to 20mhz) period jitter (rms): 3ps typical 5ps maximum period jitter (peak to peak): 20ps typical 30ps maximum 38.0mhz to 640.0mhz
|
